Configuring IGMP Snooping for IPv4 Multicast
Traffic
This chapter describes how to configure Internet Group Management Protocol (IGMP) snooping for
IPv4 multicast traffic on the Cisco 7600 series routers.
Note
•
•
This chapter consists of these sections:
•
•
•
•
•
•
For additional information (including configuration examples and troubleshooting information), see the
Tip
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Understanding How IGMP Snooping Works
These sections describe IGMP snooping:
•
•
OL-4266-08
For complete syntax and usage information for the commands used in this chapter, refer to the Cisco
IOS Master Command List, Release 12.2SX at this URL:
http://www.cisco.com/en/US/docs/ios/mcl/122sxmcl/12_2sx_mcl_book.html
To constrain IPv6 Multicast traffic, see
IPv6 Multicast Traffic."
Understanding How IGMP Snooping Works, page 30-1
Default IGMP Snooping Configuration, page 30-7
IGMP Snooping Configuration Guidelines and Restrictions, page 30-8
IGMP Snooping Querier Configuration Guidelines and Restrictions, page 30-8
Enabling the IGMP Snooping Querier, page 30-9
Configuring IGMP Snooping, page 30-9
IGMP Snooping Overview, page 30-2
Joining a Multicast Group, page 30-2
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
C H A P T E R
Chapter 29, "Configuring MLDv2 Snooping for
30
30-1