Cisco 7604 Configuration Manual page 972

Exhaustive Memory Tests
TestAclQosTcam
The TestAclQosTcam test tests all the bits and checks the location of both ACL and QOS TCAMs on the
PFC3BXL and PFC3B. It is not supported on the PFC3A.
Table A-53
Attribute
Disruptive/Nondisruptive
Recommendation
Default
Release
Corrective action
Hardware support
TestNetflowTcam
The TestNetflowTcam test tests all the bits and checks the location of the Netflow TCAM.
Table A-54
Attribute
Disruptive/Nondisruptive
Recommendation
Default
Release
Corrective action
Hardware support
TestQoSTcam
The TestQoSTcam test performs exhaustive memory tests for QoS TCAM devices.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
A-30
TestAclQosTcam Test Attributes
Description
Disruptive. Disruption is approximately one hour.
Use this test only if you suspect a problem with the hardware
or before putting the hardware into a live network. Do not run
any traffic in the background on the module that you are
testing. The supervisor engine must be rebooted after running
this test.
Off.
12.2(18)SXD.
Not applicable.
All modules including supervisor engines.
TestNetflowTcam Test Attributes
Description
Disruptive. Disruption is several minutes and can vary
depending on whether you are testing the PFC3A, PFC3BXL,
or PFC3B.
Use this test only if you suspect a problem with the hardware
or before putting the hardware into a live network. Do not run
any traffic in the background on the module that you are
testing. The supervisor engine must be rebooted after running
this test.
Off.
12.2(18)SXD.
Not applicable.
All modules including supervisor engines.
Appendix A Online Diagnostic Tests
OL-4266-08