Configuring Ipx Routing And Network Numbers - Cisco 7604 Configuration Manual

Configuring IPX Routing and Network Numbers

This example uses the show running-config command to display the interface IPv4 address
configuration of Fast Ethernet port 5/4:
Router# show running-config interfaces fastethernet 5/4
Building configuration...
Current configuration:
!
interface FastEthernet5/4
description "Router port"
ip address 172.20.52.106 255.255.255.248
no ip directed-broadcast
!
Configuring IPX Routing and Network Numbers
The MSFC supports IPX with fast switching.
Note
For complete information and procedures, refer to these publications:
•
•
To configure routing for Internetwork Packet Exchange (IPX) and configure IPX on a Layer 3 interface,
perform this task:
Command
Step 1
Router(config)# ipx routing
Step 2
Router(config)# router ipx_routing_protocol
Step 3
Router(config)# interface {vlan vlan_ID } |
1
{ type slot/port } | {port-channel
port_channel_number }
Step 4
Router(config-if)# ipx network [network |
unnumbered] encapsulation encapsulation_type
Step 5
Router(config-if)# no shutdown
Step 6
Router(config-if)# end
Step 7
Router# show interfaces [{vlan vlan_ID } |
1
{ type slot/port } | {port-channel
port_channel_number }]
Router# show ipx interfaces [{vlan vlan_ID } |
1
{ type slot/port } | {port-channel
port_channel_number }]
Router# show running-config interfaces [{vlan
vlan_ID } | { type
port_channel_number }]
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
22-8
Cisco IOS AppleTalk and Novell IPX Configuration Guide, Release 12.2, at this URL:
http://www.cisco.com/en/US/docs/ios/12_2/atipx/configuration/guide/fatipx_c.html
Cisco IOS AppleTalk and Novell IPX Command Reference, Release 12.2, at this URL:
http://www.cisco.com/en/US/docs/ios/12_2/atipx/command/reference/fatipx_r.html
1
slot/port } | {port-channel
Chapter 22
Purpose
Enables IPX routing.
Specifies an IP routing protocol. This step might include
other commands, such as specifying the networks to route
with the network command.
Selects an interface to configure.
Configures the IPX network number. This enables IPX
routing on the interface. When you enable IPX routing on
the interface, you can also specify an encapsulation type.
Enables the interface.
Exits configuration mode.
Verifies the configuration.
Configuring Layer 3 Interfaces
OL-4266-08