Configuring The Lacp System Priority And System Id - Cisco 7604 Configuration Manual

Configuring EtherChannels
Router# show interfaces fastethernet 5/6 etherchannel
Port state
Channel group = 12
Port-channel
2
Port index
Flags:
Timers: H - Hello timer is running.
Local information:
Port
Fa5/2
Age of the port in the current state: 04d:18h:57m:19s
This example shows how to verify the configuration of port channel interface 2 after the LAN ports have
been configured:
Router# show etherchannel 12 port-channel
Port-channel: Po12
------------
Age of the Port-channel
Logical slot/port
GC
Port state
Protocol
Router#

Configuring the LACP System Priority and System ID

The LACP system ID is the combination of the LACP system priority value and the MAC address of the
router.
To configure the LACP system priority and system ID, perform this task:
Command
Step 1
Router(config)# lacp system-priority
priority_value
Router(config)# no lacp system-priority
Step 2
Router(config)# end
Step 3
Router# show lacp sys-id
This example shows how to configure the LACP system priority:
Router# configure terminal
Router(config)# lacp system-priority 23456
Router(config)# end
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
12-10
= Down Not-in-Bndl
Mode = Desirable-Sl
= null GC
= 0 Load = 0x00
S - Device is sending Slow hello.
A - Device is in Auto mode.
d - PAgP is down.
S - Switching timer is running.
Flags State Timers
d U1/S1
Port-channels in the group:
----------------------
= 04d:18h:58m:50s
= 14/1
= 0x00000000
= Port-channel Ag-Not-Inuse
= PAgP
Gcchange = 0
= 0x00000000
Protocol =
C - Device is in Consistent state.
P - Device learns on physical port.
Q - Quit timer is running.
I - Interface timer is running.
Hello Partner PAgP
Interval Count Priority
1s 0 128
Number of ports = 0
HotStandBy port = null
Purpose
(Optional for LACP) Valid values are 1 through 65535.
Higher numbers have lower priority. The default is 32768.
Reverts to the default.
Exits configuration mode.
Verifies the configuration.
Chapter 12 Configuring EtherChannels
Pseudo port-channel = Po1
PAgP
Learning Group
Method Ifindex
Any 0
OL-4266-08