Cisco 7604 Configuration Manual page 370

Any Transport over MPLS
•
To support 802.1Q-in-802.1Q traffic and Ethernet traffic over EoMPLS in PFC3BXL or PFC3B mode,
configure port-based EoMPLS by performing this task:
Command
Step 1
Router# configure terminal
Step 2
Router(config)# interface
gigabitethernet slot/interface
Step 3
Router(config-if)# xconnect
peer_router_id vcid encapsulation mpls
The following is an example of a port-based configuration:
!
EoMPLS:
router# show mpls l2transport vc
Local intf
-------------
Fa8/48
Gi7/11.2000
Port-Based EoMPLS Config:
router# show run interface f8/48
Building configuration...
Current configuration : 86 bytes
!
interface FastEthernet8/48
no ip address
xconnect 75.0.78.1 1 encapsulation mpls
end
Sub-Interface Based Mode:
router# show run interface g7/11
Building configuration...
Current configuration : 118 bytes
!
interface GigabitEthernet7/11
description Traffic-Generator
no ip address
logging event link-status
speed nonegotiate
end
router# show run int g7/11.2000
Building configuration...
Current configuration : 112 bytes
!
interface GigabitEthernet7/11.2000
encapsulation dot1Q 2000
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
24-20
Port-based EoMPLS and VLAN-based EoMPLS are mutually exclusive. If you enable a main
interface for port-to-port transport, you also cannot enter commands on a subinterface.
Local circuit
-------------------- --------------- ---------- ----------
Ethernet
Eth VLAN 2000
Chapter 24 Configuring PFC3BXL and PFC3B Mode Multiprotocol Label Switching
Purpose
Enters global configuration mode.
Specifies the Gigabit Ethernet interface. Make sure that the
interface on the adjoining CE router is on the same VLAN as this
PE router.
Binds the attachment circuit to a pseudowire VC. The syntax for
this command is the same as for all other Layer 2 transports.
Dest address VC ID
75.0.78.1 1
75.0.78.1 2000
Status
UP
UP
OL-4266-08