Cisco 7604 Configuration Manual page 494

Configuring Unicast Reverse Path Forwarding Check
Configuring Multiple-Path Interface Groups on a PFC3
To configure multiple-path Unicast RPF interface groups on a PFC3, perform this task:
Command
Step 1
Router(config)# mls ip cef rpf interface-group [0
| 1 | 2 | 3] interface1 [ interface2 [ interface3
[ interface4 ]]]
Step 2
Router(config)# mls ip cef rpf interface-group
group_number
Step 3
Router(config)# end
Step 4
Router# show mls cef ip rpf
This example shows how to configure interface group 2:
Router(config)# mls ip cef rpf interface-group 2 fastethernet 3/3 fastethernet 3/4
fastethernet 3/5 fastethernet 3/6
Enabling Self-Pinging
With Unicast RPF check enabled, by default the router cannot ping itself.
To enable self-pinging, perform this task:
Command
Step 1
Router(config)# interface {{vlan vlan_ID } |
1
{ type slot/port } | {port-channel number }}
Step 2
Router(config-if)# ip verify unicast source
reachable-via any allow-self-ping
Router(config-if)# no ip verify unicast source
reachable-via any allow-self-ping
Step 3
Router(config-if)# exit
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
This example shows how to enable self-pinging:
Router(config)# interface gigabitethernet 4/1
Router(config-if)# ip verify unicast source reachable-via any allow-self-ping
Router(config-if)# end
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
33-6
Chapter 33
Purpose
Configures a multiple path RPF interface group on a
PFC3.
Removes an interface group.
Exits configuration mode.
Verifies the configuration.
Purpose
Selects the interface to configure.
Enables the router to ping itself or a secondary address.
Disables self-pinging.
Exits interface configuration mode.
Configuring Network Security
OL-4266-08