Cisco 7604 Configuration Manual page 57

Chapter 3 Configuring the Router for the First Time
Configuring the Router
When you reach and respond to the configuration dialog for the last installed interface, your interface
configuration is complete.
Step 3 Check and verify the entire list of configuration parameters, which should display on your console
terminal and end with the following query:
Use this configuration? [yes/no]:
A no response returns you to the enable prompt (#). You will need to reenter the setup command to
reenter your configuration. A yes response saves the running configuration to NVRAM as follows:
Use this configuration? [yes/no]: yes
[OK]
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started!
After you press the Return key, this prompt appears:
Router>
This completes the procedures for configuring global parameters and interface parameters in your
system. Your interfaces are now available for limited use.
If you want to modify the currently saved configuration parameters after the initial configuration, enter
the setup command. To perform more complex configurations, enter configuration mode and use the
configure command. Check the current state of the router using the show version command, which
displays the software version and the interfaces, as follows:
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) c6sup2_rp Software (c6sup2_rp-JSV-M), Version 12.1(5c)EX, EARLY DEPLOY)
Synced to mainline version: 12.1(5c)
TAC:Home:Software:Ios General:CiscoIOSRoadmap:12.1
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Wed 28-Mar-01 17:52 by hqluong
Image text-base: 0x30008980, data-base: 0x315D0000
ROM: System Bootstrap, Version 12.1(3r)E2, RELEASE SOFTWARE (fc1)
BOOTFLASH: c6sup2_rp Software (c6sup2_rp-JSV-M), Version 12.1(5c)EX, EARLY DEPL)
Router uptime is 2 hours, 33 minutes
System returned to ROM by power-on (SP by power-on)
Running default software
cisco Catalyst 6000 (R7000) processor with 114688K/16384K bytes of memory.
Processor board ID SAD04430J9K
R7000 CPU at 300Mhz, Implementation 39, Rev 2.1, 256KB L2, 1024KB L3 Cache
Last reset from power-on
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
1 Virtual Ethernet/IEEE 802.3 interface(s)
48 FastEthernet/IEEE 802.3 interface(s)
2 Gigabit Ethernet/IEEE 802.3 interface(s)
381K bytes of non-volatile configuration memory.
16384K bytes of Flash internal SIMM (Sector size 512K).
Configuration register is 0x2
Router#
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
3-9
OL-4266-08