Chapter 4
System Startup and Basic Configuration
Saving the Running Configuration Settings to NVRAM
Note
OL-11495-01
clock source internal
!
interface POS1/1
no ip address
no ip route-cache cef
no ip route-cache
shutdown
crc 32
!
interface POS1/2
no ip address
no ip route-cache cef
no ip route-cache
shutdown
crc 32
!
interface POS1/3
no ip address
no ip route-cache cef
no ip route-cache
shutdown
crc 32
The copy running-config startup-config command saves the configuration
settings that you created while in the global configuration mode to NVRAM. Be
sure to enter this command any time you make changes to configuration settings.
Milo# copy running-config startup-config
If you do not save the running configuration settings to NVRAM, they will be lost
the next time you reload the system.
Cisco 12016, Cisco 12416, and Cisco 12816 Router Installation and Configuration Guide
Cisco IOS User Interface
4-29