Sample Configurations For Mvpn; Mvpn Configuration With Default Mdts Only - Cisco 7604 Configuration Manual

Sample Configurations for MVPN

Sample Configuration
The following excerpt from a configuration file shows the interface configuration, along with the
associated MVRF configuration, to enable multicast traffic over a single MVRF:
ip multicast-routing vrf blue
ip multicast-routing
ip vrf blue
rd 100:27
route-target export 100:27
route-target import 100:27
mdt default 239.192.10.2
interface GigabitEthernet1/1
description blue connection
ip vrf forwarding blue
ip address 192.168.2.26 255.255.255.0
ip pim sparse-mode
interface GigabitEthernet1/15
description Backbone connection
ip address 10.8.4.2 255.255.255.0
ip pim sparse-mode
ip pim vrf blue rp-address 192.7.25.1
ip pim rp-address 10.1.1.1
Sample Configurations for MVPN
This section contains the following sample configurations for the MVPN feature:
•
•

MVPN Configuration with Default MDTs Only

The following excerpt from a configuration file shows the lines that are related to the MVPN
configuration for three MVRFs. (The required BGP configuration is not shown.)
!
version 12.2
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
service compress-config
!
hostname MVPN Router
!
boot system flash slot0:
logging snmp-authfail
!
ip subnet-zero
!
!
no ip domain-lookup
ip host tftp 223.255.254.238
!
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
25-22
MVPN Configuration with Default MDTs Only, page 25-22
MVPN Configuration with Default and Data MDTs, page 25-24
Chapter 25 Configuring IPv4 Multicast VPN Support
OL-4266-08