Cisco 7604 Configuration Manual page 675

Chapter 41 Configuring PFC QoS
This chapter includes the following ACL documentation:
Note
•
•
Other ACLs are not documented in this publication. See the references under access-list in the
"PFC QoS Policy Configuration Overview" section on page
Configuring Filtering in a Class Map
To configure filtering in a class map, perform one of these tasks:
Command
Router(config-cmap)# match access-group name
acl_index_or_name
Router(config-cmap)# no match access-group name
acl_index_or_name
Router (config-cmap)# match protocol ipv6
Router (config-cmap)# no match protocol ipv6
Router (config-cmap)# match precedence ipp_value1
[ ipp_value2 [ ipp_valueN ]]
Router (config-cmap)# no match precedence ipp_value1
[ ipp_value2 [ ipp_valueN ]]
Router (config-cmap)# match dscp dscp_value1
[ dscp_value2 [ dscp_valueN ]]
Router (config-cmap)# no match dscp dscp_value1
[ dscp_value2 [ dscp_valueN ]]
Router (config-cmap)# match ip precedence ipp_value1
[ ipp_value2 [ ipp_valueN ]]
Router (config-cmap)# no match ip precedence
ipp_value1 [ ipp_value2 [ ipp_valueN ]]
Router (config-cmap)# match ip dscp dscp_value1
[ dscp_value2 [ dscp_valueN ]]
Router (config-cmap)# no match ip dscp dscp_value1
[ dscp_value2 [ dscp_valueN ]]
OL-4266-08
Configuring MAC ACLs, page 41-67
Configuring ARP ACLs for QoS Filtering, page 41-70
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
41-66.
Purpose
(Optional) Configures the class map to filter using an ACL.
Clears the ACL configuration from the class map.
(Optional—for IPv6 traffic) Configures the class map to filter
IPv6 traffic.
Clears IPv6 filtering.
(Optional—for IPv4 or IPv6 traffic) Configures the class map
to filter based on up to eight IP precedence values.
Does not support source-based or destination-based
Note
microflow policing.
Clears configured IP precedence values from the class map.
(Optional—for IPv4 or IPv6 traffic only) Configures the class
map to filter based on up to eight DSCP values.
Does not support source-based or destination-based
Note
microflow policing.
Clears configured DSCP values from the class map.
(Optional—for IPv4 traffic) Configures the class map to filter
based on up to eight IP precedence values.
Does not support source-based or destination-based
Note
microflow policing.
Clears configured IP precedence values from the class map.
(Optional—for IPv4 traffic) Configures the class map to filter
based on up to eight DSCP values.
Does not support source-based or destination-based
Note
microflow policing.
Clears configured DSCP values from the class map.
Configuring PFC QoS
41-73