Configuring Netflow On The Msfc - Cisco 7604 Configuration Manual

Configuring NetFlow
Gi7/9 9.1.0.0 /16 0 3003 12M 64 1699.8
Gi7/10 11.1.0.0 /16 0 3000 9873K 64 1699.8
Router#
This example shows how to display the NetFlow Aggregation flow mask information:
Router# show mls netflow aggregation flowmask
Current flowmask set for netflow aggregation : Vlan Full Flow
Netflow aggregations configured/enabled :
Router#
Enabling NetFlow for Ingress-Bridged IP Traffic
NetFlow for ingress-bridged IP traffic on the PFC is enabled when you configure NetFlow for
ingress-bridged IP traffic on the MSFC. See the
section on page
Enabling NetFlow for Multicast IP Traffic
NetFlow for multicast IP traffic on the PFC is enabled when you configure NetFlow for multicast IP
traffic on the MSFC. NetFlow for multicast IP traffic is supported in Release 12.2(18)SXF and later
releases.
For additional information, see the
Displaying PFC Netflow Information
To display information about NetFlow on the PFC, use the following command:
Command
Router(config)# show mls netflow {aggregation | aging
| creation | flowmask | ip | ipv6 | mpls |
table-contention | usage}

Configuring NetFlow on the MSFC

These sections describe how to configure NetFlow on the MSFC:
•
•
•
•
•
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
50-10
AS Aggregation
PROTOCOL-PORT Aggregation
SOURCE-PREFIX Aggregation
DESTINATION-PREFIX Aggregation
50-12.
Summary of NetFlow Commands on the MSFC, page 50-11
Enabling NetFlow on the MSFC, page 50-11
Configuring NetFlow Aggregation on the MSFC, page 50-11
Enabling NetFlow for Ingress-Bridged IP Traffic, page 50-12
Enabling NetFlow for Multicast IP Traffic, page 50-13
"Enabling NetFlow for Ingress-Bridged IP Traffic"
"Enabling NetFlow for Multicast IP Traffic" section on page
Purpose
Displays information about NetFlow on the PFC.
Chapter 50 Configuring NetFlow
50-13.
OL-4266-08