Mst Regions; Boundary Ports - Cisco 7604 Configuration Manual

Chapter 20 Configuring STP and Prestandard IEEE 802.1s MST
•
You must configure each byte manually. You can use SNMP or the CLI to perform the configuration.
MST BPDUs contain the MST configuration ID and the checksum. An MST bridge accepts an MST
BPDU only if the MST BPDU configuration ID and the checksum match its own MST region
configuration ID and checksum. If one value is different, the MST BPDU is considered to be an
SST BPDU.

MST Regions

These sections describe MST regions:
•
•
•
•
•
MST Region Overview
Interconnected bridges that have the same MST configuration are referred to as an MST region. There
is no limit on the number of MST regions in the network.
To form an MST region, bridges can be either of the following:
•
•
If you connect two MST regions with different MST configurations, the MST regions do the following:
•
•

Boundary Ports

A boundary port is a port that connects to a LAN, the designated bridge, of which is either an SST bridge,
or a bridge with a different MST configuration. A designated port knows that it is on the boundary if it
detects an STP bridge or receives an agreement message from an RST or MST bridge with a different
configuration.
At the boundary, the role of MST ports do not matter; their state is forced to be the same as the IST port
state. If the boundary flag is set for the port, the MSTP port-role selection process assigns a port role to
the boundary and assigns the same state as the state of the IST port. The IST port at the boundary can
take up any port role except a backup port role.
OL-4266-08
MST configuration table—An array of 4096 bytes. Each byte, interpreted as an unsigned integer,
corresponds to a VLAN. The value is the instance number to which the VLAN is mapped. The first
byte that corresponds to VLAN 0 and the 4096th byte that corresponds to VLAN 4095 are unused
and always set to zero.
MST Region Overview, page 20-19
Boundary Ports, page 20-19
IST Master, page 20-20
Edge Ports, page 20-20
Link Type, page 20-20
An MST bridge that is the only member of the MST region.
An MST bridge interconnected by a LAN. A LAN's designated bridge has the same MST
configuration as an MST bridge. All the bridges on the LAN can process MST BPDUs.
Load balance across redundant paths in the network. If two MST regions are redundantly connected,
all traffic flows on a single connection with the MST regions in a network.
Provide an RSTP handshake to enable rapid connectivity between regions. However, the
handshaking is not as fast as between two bridges. To prevent loops, all the bridges inside the region
must agree upon the connections to other regions. This situation introduces a delay. We do not
recommend partitioning the network into a large number of regions.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Understanding How Prestandard IEEE 802.1s MST Works
20-19