Saving The Running Configuration Settings To Nvram - Cisco Gigabit Switch Router 12008 Installation And Configuration Manual

Configuring the Cisco 12008
no service tcp-small-servers
!
hostname Turing
-------------!
enable password lab
!
no ip domain-lookup
ip host ray 172.27.136.253
ip host crusty 171.69.209.28
!
!
interface POS6/0
!

Saving the Running Configuration Settings to NVRAM

To save the running configuration settings to NVRAM, enter the following command at the
privileged EXEC mode prompt (
Router# copy running-config startup-config
As an alternative, you can also use the following command to save the running
configuration settings:
Router# write memory
Either command saves to NVRAM the configuration settings that you created while in the
global configuration mode.
If you fail to take this step, your configuration settings will be lost the next time you reload
the system.
4-30
Cisco 12008 Gigabit Switch Router Installation and Configuration Guide
ip address 12.1.1.1 255.255.255.0
crc 32
):
Router#