Cisco 7604 Configuration Manual page 390

Ios software configuration guide
Hide thumbs Also See for 7604:
Table of Contents

Advertisement

Configuring MVPN
Enabling IPv4 Multicast Routing Globally
To enable IPv4 multicast routing globally, perform this task:
Command or Action
Step 1
Router# configure terminal
Step 2
Router(config)# ip multicast-routing
Router(config)# no ip multicast-routing
This example show how to enable IPv4 multicast routing globally:
Router# configure terminal
Router(config)# ip multicast-routing
Enabling IPv4 Multicast VRF Routing
To enable IPv4 multicast VRF routing, perform this task:
Command or Action
Router(config)# ip multicast-routing vrf vrf_name
[distributed]
Router(config)# no ip multicast-routing
When enabling IPv4 multicast VRF routing, note the following information:
This example show how to enable IPv4 multicast VRF routing:
Router# configure terminal
Router(config)# ip multicast-routing vrf blue
Configuring a PIM VRF Register Message Source Address
To configure a PIM VRF register message source address, perform this task:
Command or Action
Router(config)# ip pim vrf vrf_name register-source
interface_type interface_number
Router(config)# no ip pim vrf vrf_name
register-source
This example show how to configure a PIM VRF register message source address:
Router(config)# ip pim vrf blue register-source loopback 3
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
25-16
vrf_name—Specifies a particular VRF for multicast routing. The vrf_name should refer to a VRF
that has been previously created, as specified in the
Forwarding Instance" section on page
distributed—(Optional) Enables Multicast Distributed Switching (MDS).
Chapter 25
Purpose
Enters global configuration mode.
Enables IPv4 multicast routing globally.
Disables IPv4 multicast routing globally.
Purpose
Enables IPv4 multicast VRF routing.
Disables IPv4 multicast VRF routing.
"Configuring a Multicast VPN Routing and
25-9.
Purpose
(Optional) Configures a PIM VRF register message source
address. You can configure a loopback interface as the source
of the register messages.
Disables IPv4 multicast VRF routing.
Configuring IPv4 Multicast VPN Support
OL-4266-08

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

761376067609-s7600 series

Table of Contents