Chapter 6
Configuring the Supervisor Engine 2 and the Switch Fabric Module
If you enter the fabric required command on a router that does not have a Switch Fabric Module
Caution
installed, all modules except the supervisor engine turn off.
When configuring fabric-required mode, note the following information:
•
•
•
Configuring an LCD Message
To configure a message for display on the LCD, perform this task:
Command
Router(config)# fabric lcd-banner d message d
Router(config)# no fabric lcd-banner
When configuring a message for display on the LCD, note the following information:
•
•
Monitoring the Switch Fabric Module
The Switch Fabric Module supports a number of show commands for monitoring purposes. A fully
automated startup sequence brings the module online and runs the connectivity diagnostics on the ports.
These sections describe how to monitor the Switch Fabric Module:
•
•
•
•
•
•
OL-4266-08
If you boot the router with fabric-required mode configured but without a Switch Fabric Module
installed, only the supervisor engine receives power; no switching modules power up.
When the router is operating with fabric-required mode configured and a Switch Fabric Module
installed, if you remove the switch fabric module or if it fails, the router removes power from all
switching modules; only the supervisor engine remains active.
When the router is operating with fabric-required mode configured and with redundant Switch
Fabric Modules installed, if you remove both switch fabric modules or if both fail, the router
removes power from all switching modules; only the supervisor engine remains active.
The d parameter is a delimiting character. You cannot use the delimiting character in the message.
The delimiter is a character of your choice—a pound sign (#), for example.
You can use the following tokens, in the form $(token), in the message text:
–
$(hostname)—Displays the router's host name.
–
$(domain)—Displays the router's domain name.
Displaying the Module Information, page 6-7
Displaying the Switch Fabric Module Redundancy Status, page 6-7
Displaying Fabric Channel Switching Modes, page 6-7
Displaying the Fabric Status, page 6-8
Displaying the Fabric Utilization, page 6-8
Displaying Fabric Errors, page 6-8
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Purpose
Configures a message for display on the LCD.
Clears the message displayed on the LCD.
Monitoring the Switch Fabric Module
6-5