Cisco 7604 Configuration Manual page 388

Configuring MVPN
To display information about a specific tunnel interface, use the show interface tunnel command. The
Note
IPv4 address for the tunnel interface is the multicast group address for the default MDT of the MVRF.
To display additional information about the MDTs, use the show mls ip multicast mdt command. The
following example shows typical output for this command:
Router# show mls ip multicast mdt
State: H - Hardware Installed, I - Install Pending, D - Delete Pending,
VRF
BIDIR01HWRP
BIDIR01SWRP
SPARSE01HWRP
SPARSE01SWRP
Router#
To display routing information for a particular VRF, use the show ip route vrf command:
Router# show ip route vrf red
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
Gateway of last resort is not set
C
B
C
B
Router#
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
25-14
Z - Zombie
MMLS
VPN-ID
1
2
3
4
red 5
red 5
red 5
red 5
red 5
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
* - candidate default, U - per-user static route, o - ODR
P - periodic downloaded static route
2.0.0.0/32 is subnetted, 1 subnets
2.2.2.2 is directly connected, Loopback2
3.0.0.0/32 is subnetted, 1 subnets
3.3.3.3 [200/0] via 3.1.1.3, 00:20:09
21.0.0.0/8 is directly connected, GigabitEthernet3/16
22.0.0.0/8 [200/0] via 3.1.1.3, 00:20:09
Chapter 25
MDT INFO
(10.10.10.9, 227.1.0.1)
(10.10.10.9, 227.2.0.1)
(10.10.10.9, 228.1.0.1)
(10.10.10.9, 228.2.0.1)
(6.6.6.6, 234.1.1.1)
(131.2.1.2, 228.1.1.75)
(131.2.1.2, 228.1.1.76)
(131.2.1.2, 228.1.1.77)
(131.2.1.2, 228.1.1.78)
Configuring IPv4 Multicast VPN Support
MDT Type State
default H
default H
default H
default H
default H
data (send) H
data (send) H
data (send) H
data (send) H
OL-4266-08