Enabling And Disabling Snmp Ifindex Persistence On Specific Interfaces; Clearing Snmp Ifindex Persistence Configuration From A Specific Interface - Cisco 7604 Configuration Manual

Chapter 53 Configuring SNMP IfIndex Persistence

Enabling and Disabling SNMP IfIndex Persistence on Specific Interfaces

To enable SNMP ifIndex persistence only on a specific interface, perform this task:
Command
Step 1
Router(config)# interface {vlan vlan_ID } |
1
{ type slot/port } | {port-channel
port_channel_number }
Step 2
Router(config-if)# snmp ifindex persist
Router(config-if)# no snmp ifindex persist
Step 3
Router(config-if)# exit
1. type = any supported interface type.
The [no] snmp ifindex persistence interface command cannot be used on subinterfaces. A command
Note
applied to an interface is automatically applied to all the subinterfaces associated with that interface.
In the following example, SNMP ifIndex persistence is enabled for Ethernet interface 3/1 only:
router(config)# interface ethernet 3/1
router(config-if)# snmp ifindex persist
router(config-if)# exit
In the following example, SNMP ifIndex persistence is disabled for Ethernet interface 3/1 only:
router(config)# interface ethernet 3/1
router(config-if)# no snmp ifindex persist
router(config-if)# exit

Clearing SNMP IfIndex Persistence Configuration from a Specific Interface

To clear the interface-specific SNMP ifIndex persistence setting and configure the interface to use the
global configuration setting, perform this task:
Command
Step 1
Router(config)# interface type slot/port
Step 2
Router(config-if)# snmp ifindex clear
Step 3
Router(config-if)# exit
OL-4266-08
Purpose
Selects an interface to configure.
Enables SNMP ifIndex persistence on the specified
interface.
Disables SNMP ifIndex persistence on the specified
interface.
Exits interface configuration mode.
Purpose
Enters interface configuration mode for the specified
interface. Note that the syntax of the interface command
will vary depending on the platform you are using.
Clears any interface-specific SNMP ifIndex persistence
configuration for the specified interface and returns to the
global configuration setting.
Exits interface configuration mode.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Configuring SNMP IfIndex Persistence
53-3