Displaying The Shared And Well-Known Hardware Adjacency Counters - Cisco 7604 Configuration Manual

Using show Commands to Verify IPv6 Multicast Layer 3 Switching

Displaying the Shared and Well-Known Hardware Adjacency Counters

The show platform software ipv6-multicast shared-adjacencies command displays the shared and
well-known hardware adjacency counters used for IPv6 multicast by entries in FIB and ACL-TCAM.
Router# show platform software ipv6-multicast shared-adjacencies
---- SLOT [1] ----
Shared IPv6 Mcast Adjacencies Index
----------------------------- ------ ------------- ------------------
Subnet bridge adjacency
Control bridge adjacency
StarG_M bridge adjacency
S_G bridge adjacency
Default drop adjacency
StarG (spt == INF) adjacency
StarG (spt != INF) adjacency
---- SLOT [6] ----
Shared IPv6 Mcast Adjacencies Index
----------------------------- ------ ------------- ------------------
Subnet bridge adjacency
Control bridge adjacency
StarG_M bridge adjacency
S_G bridge adjacency
Default drop adjacency
StarG (spt == INF) adjacency
StarG (spt != INF) adjacency
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
27-8
Chapter 27 Configuring IPv6 Multicast PFC3 and DFC3 Layer 3 Switching
Packets Bytes
0x7F802 0
0x7 0
0x8 0
0x9 0
0xA 0
0xB 0
0xC 0
Packets Bytes
0x7F802 0
0x7 0
0x8 0
0x9 0
0xA 28237
0xB 0
0xC 0
0
0
0
0
0
0
0
0
0
0
0
3146058
0
0
OL-4266-08