Cisco 7604 Configuration Manual page 246

Configuring Support for Layer 2 Protocol Tunneling
----------------------------------------
Fa5/1
Router#
This example shows how to display counter information for port 5/1:
Router# show l2protocol-tunnel interface fastethernet 5/1
Port
--------------------------------------------------------------
Router#
This example shows how to clear the Layer 2 protocol tunneling configuration from port 5/1:
Router(config-if)# no l2protocol-tunnel shutdown-threshold cdp 10
Router(config-if)# no l2protocol-tunnel shutdown-threshold stp 10
Router(config-if)# no l2protocol-tunnel shutdown-threshold vtp 10
Router(config-if)# no l2protocol-tunnel cdp
Router(config-if)# no l2protocol-tunnel stp
Router(config-if)# no l2protocol-tunnel vtp
Router(config-if)# end
Router# show l2protocol-tunnel summary
Port
----------------------------------------
Router#
This example shows how to clear Layer 2 protocol tunneling port counters:
Router# clear l2protocol-tunnel counters
Router#
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
18-4
(cos/cdp/stp/vtp)
cdp stp vtp 0/10
Protocol Threshold
(cos/cdp/stp/vtp)
Protocol Threshold
(cos/cdp/stp/vtp)
Chapter 18
/10 /10 down trunk
Counters
(cdp/stp/vtp/decap)
Configuring Layer 2 Protocol Tunneling
OL-4266-08