Cisco 7604 Configuration Manual page 241

Chapter 17 Configuring IEEE 802.1Q Tunneling
To configure the router to tag traffic in the native VLAN, perform this task:
Command
Step 1
Router(config)# vlan dot1q tag native
Router(config)# no vlan dot1q tag native
Step 2
Router(config)# end
Step 3
Router# show vlan dot1q tag native
This example shows how to configure the router to tag native VLAN traffic and verify the configuration:
Router# configure terminal
Router(config)# vlan dot1q tag native
Router(config)# end
Router# show vlan dot1q tag native
For additional information (including configuration examples and troubleshooting information), see the
Tip
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
OL-4266-08
Purpose
Configures the router to tag native VLAN traffic.
Clears the configuration.
Exits configuration mode.
Verifies the configuration.
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Configuring 802.1Q Tunneling
17-7