Configuring Etherchannel Load Balancing - Cisco 7604 Configuration Manual

Chapter 12 Configuring EtherChannels
Router(config)#
This example shows how to verify the configuration:
Router# show lacp sys-id
23456,0050.3e8d.6400
Router#
The system priority is displayed first, followed by the MAC address of the router.

Configuring EtherChannel Load Balancing

To configure EtherChannel load balancing, perform this task:
Command
Step 1
Router(config)# port-channel load-balance
{src-mac | dst-mac | src-dst-mac | src-ip |
dst-ip | src-dst-ip | src-port | dst-port |
src-dst-port}
Router(config)# no port-channel load-balance
Step 2
Router(config)# end
Step 3
Router# show etherchannel load-balance
The load-balancing keywords indicate the following information:
•
•
•
•
•
•
•
•
•
•
This example shows how to configure EtherChannel to use source and destination IP addresses:
Router# configure terminal
Router(config)# port-channel load-balance src-dst-ip
Router(config)# end
Router(config)#
This example shows how to verify the configuration:
Router# show etherchannel load-balance
Source XOR Destination IP address
Router#
OL-4266-08
dst-ip—Destination IP addresses
dst-mac—Destination MAC addresses
dst-port—Destination Layer 4 port
mpls—Load balancing for MPLS packets
src-dst-ip—Source and destination IP addresses
src-dst-mac—Source and destination MAC addresses
src-dst-port—Source and destination Layer 4 port
src-ip—Source IP addresses
src-mac—Source MAC addresses
src-port—Source Layer 4 port
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Purpose
Configures EtherChannel load balancing.
Reverts to default EtherChannel load balancing.
Exits configuration mode.
Verifies the configuration.
Configuring EtherChannels
12-11