Page of 7

HP D7171A - NetServer - LPr Frequently Asked Questions Manual

Hp netserver lc 2000 frequently asked questions.
Hide thumbs
   
Hewlett-Packard
Network Server Division
HP NetServer LC 2000
Frequently Asked Questions

Advertising

   Related Manuals for HP D7171A - NetServer - LPr

   Summary of Contents for HP D7171A - NetServer - LPr

  • Page 1

    Hewlett-Packard Network Server Division HP NetServer LC 2000 Frequently Asked Questions...

  • Page 2

    HP NetServer LC 2000 Frequently Asked Questions Which Processors are supported in the NetServer LC 2000 The NetServer LC 2000 supports Intel Pentium III 533 MHz, P III 600 MHz, P III 667 MHz and PIII 733 MHz processors. What is new on the front panel of the NetServer LC 2000? The Power ON/Off/Sleep button The power button acts as both a button for transitioning the system between the off and on states, and a button for transitioning the system between the on and sleep state...

  • Page 3

    What are the available ports and connectors on the rear of the NetServer LC 2000 One RJ-45 LAN connector and two LEDs to indicate LAN speed and link Serial Port A Embedded Remote Management Port or Serial Port B Parallel Port (ECP/EPP) Mouse Port Keyboard Port Monitor Port (SVGA)

  • Page 4

    SCSI Device ID 0 SCSI Device ID 9 PCI P1 PCI P2 PCI P3 PCI P4 PCI P5 10. PCI P6 On each controller, the server scans for a boot device starting at device ID 0 and works up the ID numbers.

  • Page 5

    Q11. What utility is used to configure the embedded SCSI controller configuration? A11. The BIOS has the SCSI configuration utility. SCSI configuration is used for configuring embedded SCSI controllers and devices connected to the SCSI controllers. Features provided using this utility include the option of reassigning the designation of channel A and B, verify or modify SCSI host adapter settings, to low-level format SCSI disks, or verify SCSI media.

  • Page 6

    Q17. What is the PCI slot initialization order? What types of PCI cards are supported in these slots? A17. During system boot, the PCI slots are initialized in the following order: PCI slot P1 PCI slot P2 PCI slot P3 PCI slot P4 PCI slot P5 PCI slot P6...

  • Page 7

    Navigator CD E 10.10 or L.17.00. A D5013A/B NIC card can be added to the system for Adapter Fault Tolerance (AFT). Q23. What additional details are available on the exact purpose of the two LAN adapter LED’s? i.e. Link and Activity, what behavior should be expected? A23.

Comments to this Manuals

Symbols: 0
Latest comments: