Step 3: Placing The Hp Netserver In The Rack - HP D5970A - NetServer - LCII Installation Manual

Chapter 8

Step 3: Placing the HP NetServer in the Rack

WARNING
If you have not done so already, pull the rack's stabilizing
foot forward out of the bottom of the rack to prevent rack
instability while mounting the HP NetServer. Failure to do so
could result in injury and equipment damage. Figure 8-5
shows the stabilizing foot in position.
1. Before lifting the HP NetServer, remove all three power supply modules.
Pull down the black handle on each module, then pull the module out of
the server. See Figure 8-6.
Figure 8-6. Removing the Power Supply Modules
WARNING The HP NetServer weighs more than 130 pounds. Removing
the power supplies reduces this weight significantly and
reduces the likelihood of accidents. Reinstall the power
supplies only after the server is securely mounted. At least
two people must be on hand to lift the server into position.
Failure to observer this warning could result in serious injury
to you or damage to the HP NetServer.
82
Mounting the Server in the Rack