Installing A Dimm - HP Z200 - Small Form Factor Workstation Maintenance And Service Manual

Installing a DIMM

To install the DIMM:
1. Prepare the computer for servicing by following the
CAUTION:
data loss.
2. Remove the access panel (see
3. Rotate the drive cage to its upright position.
Figure 5-47
4. Push gently outward on the DIMM socket levers.
108 Chapter 5 Replacing components
Failure to follow the predisassembly procedures can result in equipment damage or
Removing the access panel on page
Rotating the drive cage up
Predisassembly procedures on page
71).
68.
ENWW