Installing A Dimm - HP Z400 - Workstation Maintenance And Service Manual

Installing a DIMM

To install the DIMM:
1. Power down the workstation (see
2. Disconnect power from the workstation (see
CAUTION:
the workstation and unplug the power cord from the AC power outlet. Otherwise, the workstation
may not recognize the memory changes.
3. Remove the side access panel (see
4. If your system has an airflow guide, remove it (see
5. Push gently outward on the DIMM socket levers as shown in the following figure.
Figure 5-35
ENWW
Predisassembly procedures on page
To prevent electrical damage to the DIMMs during removal or installation, power off
Opening DIMM socket levers
Predisassembly procedures on page
Removing the side access panel on page
Removing the airflow guide on page
Removing and installing components
69).
69).
72).
92).
99