Download  Print this page

Installing A Dimm - HP Xw8400 - Workstation - 4 GB RAM User Manual

Hp xw8400 service and technical reference guide.
Hide thumbs

Advertisement

Load the memory module pairs in order of size, from smallest to largest.
Figure 4-15
The BIOS generates warnings/errors on invalid memory configurations.
If there is no way to obtain a valid memory configuration by disabling some of the plugged-in
memory, the BIOS will halt with a diagnostics 2006 code for memory error (five beeps and blinks).
If the BIOS can find a valid memory configuration by disabling some of the plugged-in memory, it
will do so and report a warning during POST ("215-mismatched memory"). The system can still be
booted in this condition.

Installing a DIMM

1.
Disconnect power from the system (
access panel
facing up.
2.
Press the green tab at the base of the memory fan (1) and lift it up (2) to expose the memory
modules.
Figure 4-16
70
Chapter 4 Removal and replacement procedures
Identifying memory slots
(Access panel on page
Rotating the memory fan
Pre-disassembly procedures on page
60). Lay the workstation on its side with the system board
55) and remove the
ENWW

Advertisement

Table of Contents

   Related Manuals for HP Xw8400 - Workstation - 4 GB RAM

Comments to this Manuals

Symbols: 0
Latest comments: