Installing The System Battery - Dell PowerEdge C8220 Hardware Owner's Manual

Figure 3-40. Removing and Installing the System Battery
1 system battery

Installing the System Battery

WARNING:
installed. Replace the battery only with the same or equivalent type recommended
by the manufacturer. See your safety information for additional information.
CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized is not covered by
warranty. Read and follow the safety instructions that came with the product.
1 Hold the new battery with the "+" facing the retention clip on the battery
connector. See Figure 3-40.
2 Insert the "-" side of the battery then push the positive side
3 Gently pull the retention clip towards the positive side of the connector
and slide the battery into the connector until the retention clip snaps into
place. See Figure 3-40.
4 Replace the front cover. See "Installing the Front Cover" on page 149.
5 Replace the sled. See "Installing a Sled" on page 144.
6 Reconnect the system to the electrical outlet and turn the system on,
including any attached peripherals.
200
Installing System Components
There is a danger of a new battery exploding if it is incorrectly
Many repairs may only be done by a certified service technician. You
2 connector