Installing The System Battery - Dell PowerEdge T105 Systems Hardware Owner's Manual

Figure 3-26. Removing and Installing the System Battery
1 battery socket
3 tab

Installing the System Battery

1 Install the new battery with the "+" facing up, and press down until it
snaps into place. See Figure 3-26.
2 Close the system. See "Closing the System" on page 47.
3 Reconnect the system to the electrical outlet and turn on the system and
attached peripherals.
4 Enter the System Setup program to confirm that the battery operates
properly. See "Using the System Setup Program" on page 31.
5 From the main screen, select System Time to enter the correct time and
date.
6 Re-enter any system configuration information that is no longer displayed
on the System Setup screens, and then exit the System Setup program.
7 To test the newly installed battery, see "Troubleshooting the System
Battery" on page 111.
8 After an hour, reconnect the system to a power source and turn it on.
9 Enter the System Setup program. If the time and date are still incorrect,
see "Getting Help" on page 137.
90
Installing System Components
1
2
3
2 system battery