Installing The System Battery - Dell EMC PowerEdge C6420 Manual

Figure 60. Removing system battery
Next step
Install the system battery.
Related link
Removing a sled
Removing the expansion card riser assembly

Installing the system battery

Installing the system battery
Prerequisites
WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your
system.
NOTE: Battery is a Field Replaceable Unit (FRU). Removal and installation procedures are to be performed only by Dell certified
service technicians.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
Steps
1 Locate the battery socket. For more information, see the System board connectors section.
2 Hold the battery with the "+" facing up and slide it under the securing tabs.
3 Press the battery into the connector until it snaps into place.
116 Installing and removing system components
Safety instructions.
Before working inside your system.