Configuring Stp; Understanding Spanning-Tree Features - Cisco WS-C3750-48PS-S Software Configuration Manual

Configuring STP

This chapter describes how to configure the Spanning Tree Protocol (STP) on port-based VLANs on the
Catalyst 3750 switch. The switch uses the per-VLAN spanning-tree plus (PVST+) protocol based on the
IEEE 802.1D standard and Cisco proprietary extensions, or it can use the rapid per-VLAN spanning-tree
plus (rapid-PVST+) protocol based on the IEEE 802.1w standard. A switch stack appears as a single
spanning-tree node to the rest of the network, and all stack members use the same bridge ID. Unless
otherwise noted, the term switch refers to a standalone switch and to a switch stack.
For information about the Multiple Spanning Tree Protocol (MSTP) and how to map multiple VLANs
to the same spanning-tree instance, see
spanning-tree features such as Port Fast, UplinkFast, root guard, and so forth, see
"Configuring Optional Spanning-Tree Features."
For complete syntax and usage information for the commands used in this chapter, refer to the command
Note
reference for this release.
This chapter consists of these sections:
•
•
•

Understanding Spanning-Tree Features

These sections describe how basic spanning-tree features work:
•
•
•
•
•
•
•
•
•
78-16180-02
Understanding Spanning-Tree Features, page 17-1
Configuring Spanning-Tree Features, page 17-12
Displaying the Spanning-Tree Status, page 17-24
STP Overview, page 17-2
Spanning-Tree Topology and BPDUs, page 17-3
Bridge ID, Switch Priority, and Extended System ID, page 17-4
Spanning-Tree Interface States, page 17-5
How a Switch or Port Becomes the Root Switch or Root Port, page 17-8
Spanning Tree and Redundant Connectivity, page 17-9
Spanning-Tree Address Management, page 17-9
Accelerated Aging to Retain Connectivity, page 17-9
Spanning-Tree Modes and Protocols, page 17-10
C H A P T E R
Chapter 18, "Configuring MSTP."
Catalyst 3750 Switch Software Configuration Guide
17
For information about other
Chapter 19,
17-1