Routing For Ports - NETGEAR GSM7228PS Software Administration Manual
Managed switch release 8.0.3
Hide thumbs
Also See for GSM7228PS:
- Cli manual (788 pages) ,
- Datasheet (15 pages) ,
- User manual (628 pages)
Table of Contents
Advertisement
Routing for Ports
The example is shown as CLI commands and as a Web interface procedure.
CLI: Enable Routing and Assigning IP Addresses for Ports 1/0/2
and 1/0/3
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#routing
(Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.255.0
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#routing
(Netgear Switch) (Interface 1/0/3)#ip address 192.150.3.1 255.255.255.0
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#exit
Web Interface: Enable Routing for the Ports
1.
Assign IP address 192.150.2.1/24 to interface 1/0/2.
a. Select Routing > Advanced > IP Interface Configuration. A screen similar to the
following displays.
b. Scroll down and select the Interface 1/0/2 check box. Now 1/0/2 appears in the
Interface field at the top.
c. Enter the following information:
•
In the IP Address field, enter 192.150.2.1.
•
In the Subnet Mask field, enter 255.255.255.0.
•
In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
56 |
Chapter 6. RIP
ProSafe 7000 Managed Switch Release 8.0.3
Advertisement
Table of Contents
