ProSafe 7000 Managed Switch Release 8.0.3
d. Click the gray box under port 3 until T displays. The T specifies that the egress
packet is tagged for the port.
e.
Click Apply to save the VLAN that includes port 3.
3.
Enable RIP on the switch (you can skip this step since the RIP is enabled by default).
a. Select Routing > RIP > Basic > RIP Configuration. A screen similar to the following
displays.
b. For RIP Admin Mode, select the Enable radio button.
c. Click Apply to save the setting.
4.
Enable RIP on VLANs 10 and 20.
a. Select Routing > RIP > Advanced > RIP Configuration. A screen similar to the
following displays.
b. Enter the following information:
•
In the Interface list, select 0/2/1.
•
For RIP Admin Mode, select the Enable radio button.
c. Click Apply to save the settings.
Chapter 6. RIP
| 63