Create A Static Address; Protected Ports - NETGEAR GSM7228PS Software Administration Manual
Managed switch release 8.0.3
Hide thumbs
Also See for GSM7228PS:
- Cli manual (788 pages) ,
- Datasheet (15 pages) ,
- User manual (628 pages)
Table of Contents
Advertisement
Create a Static Address
The example is shown as CLI commands and as a Web interface procedure.
CLI: Create a Static Address
(Netgear Switch) (Interface 1/0/1)#port-security mac-address 00:13:00:01:02:03
Web Interface: Create a Static Address
1.
Select Security > Traffic Control > Port Security > Static MAC address. A screen
similar to the following displays.
2.
Under Port List, in the Interface list, select 1/0/1.
3.
In the Static MAC Address section of the screen, enter the following information:
•
In the Static MAC Address field, enter 00:13:00:01:02:03.
•
In the Vlan ID list, select 3.
4.
Click Add.
Protected Ports
This section describes how to set up protected ports on the switch. Some situations might
require that traffic is prevented from being forwarded between any ports at Layer 2 so that
one user cannot see the traffic of another user on the same switch. Protected ports can:
•
Prevent traffic from being forwarded between protected ports.
•
Allow traffic to be forwarded between a protected port and a non-protected port.
230 |
Chapter 14. Security Management
ProSafe 7000 Managed Switch Release 8.0.3
Advertisement
Table of Contents
