NETGEAR GSM7228PS Software Administration Manual page 367

ProSafe 7000 Managed Switch Release 8.0.3
To access the switch over an IPv6 network you must first configure it with IPv6 information
(IPv6 prefix, prefix length, and default gateway).
CLI: Configure the IPv6 Network Interface
(Netgear Switch) #network ipv6 enable
(Netgear Switch) #network ipv6 address 2001:1::1/64
(Netgear Switch) #network ipv6 gateway 2001:1::2
(Netgear Switch) #show network
Interface Status............................... Always Up
IP Address..................................... 0.0.0.0
Subnet Mask.................................... 0.0.0.0
Default Gateway................................ 0.0.0.0
IPv6 Administrative Mode....................... Enabled
IPv6 Prefix is ................................ FE80::2FF:F9FF:FE70:485/64
IPv6 Prefix is ................................ 2001:1::1/64
IPv6 Default Router............................ 2001:1::2
Burned In MAC Address.......................... 00:FF:F9:70:04:85
Locally Administered MAC address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Configured IPv4 Protocol....................... None
Configured IPv6 Protocol....................... None
IPv6 AutoConfig Mode........................... Disabled
Management VLAN ID.............................1
Web Interface: Configure the IPv6 Network Interface
1. Add an IPv6 address to the network interface.
a. Select System > Management > Network Interface > IPv6 Network
Configuration. A screen similar to the following displays.
b. For Admin Mode, select the Enable radio button.
c. In the IPv6 Prefix/Prefix Length field, enter 2001:1::1/64.
Chapter 25. IPv6 Interface Configuration | 367