Create An Ipv6 Network Interface - NETGEAR GSM7228PS Software Administration Manual

a. Select Routing > IPv6 > Advanced > Interface Configuration. A screen similar to
the following displays.
b. Under IPv6 Interface Configuration, scroll down and select the Interface 1/0/1 check
box. Now 1/0/1 appears in the Interface field at the top.
c. In the IPv6 Mode field, select Enable.
d. Click Apply to save the settings.
3. Assign an IPv6 address to the routing interface.
a. Select Routing > IPv6 > Advanced > Prefix Configuration. A screen similar to the
following displays.
b. In the Interface list, select 1/0/1.
c. In the IPv6 Prefix field, enter 2000::2.
d. In the Length field, enter 64.
e. In the EUI64 field, select Disable.
f. Click Add.

Create an IPv6 Network Interface

The IPv6 network interface is the logical interface used for in-band connectivity with the
switch using any of the switch's front panel ports. The configuration parameters associated
with the switch's network interface do not affect the configuration of the front panel ports
through which traffic is switched or routed.
366 | Chapter 25. IPv6 Interface Configuration
ProSafe 7000 Managed Switch Release 8.0.3