NETGEAR GSM7228PS Software Administration Manual page 236

a. Select Routing > Routing Table > Basic > Route Configuration. A screen similar to
the following displays.
b. Under Configure Routes, in the Route Type list, select Default Route.
c. In the Next Hop IP Address field, enter 10.100.5.252.
d. Click Add to add the route that is associated to VLAN 202 to the Learned Routes
table.
6. Configure port 23 and port 24 as protected ports:
a. Select Security > Traffic Control > Protected Port. A screen similar to the following
displays.
b. Under Protected Ports Configuration, click Unit 1. The ports display.
• Click the gray box under port 23. A check mark displays in the box.
• Click the gray box under port 24. A check mark displays in the box.
c. Click Apply to activate ports 23 and 24 as protected ports.
236 | Chapter 14. Security Management
ProSafe 7000 Managed Switch Release 8.0.3