NETGEAR GSM7228PS Software Administration Manual page 393

ProSafe 7000 Managed Switch Release 8.0.3
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Scroll down and select the Port 1/0/22 check box. Now 1/0/22 appears in the
Interface field at the top.
c. Enter the following information:
• In the IP Address field, enter 192.168.6.2.
• In the Subnet Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
4. Configure 1/0/24 as a routing port and assign an IP address to it.
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Scroll down tand select the Port 1/0/24 check box. Now 1/0/24 appears in the
Interface field at the top.
c. Enter the following information:
• In the IP Address field, enter 192.168.4.1.
• In the Subnet Mask field, enter 255.255.255.0.
• In the Routing Mode field, select Enable.
d. Click Apply to save the settings.
5. Enable RIP on interface 1/0/21.
Chapter 26. PIM | 393