Web Interface: Show Logging Hosts
Select Monitoring > Logs > Sys Log Configuration. A screen similar to the following
displays.
Configure Logging for a Port
The example is shown as CLI commands and as a Web interface procedure.
CLI: Configure Logging for the Port
(Netgear Switch Routing)
(Netgear Switch Routing) (Config)#logging ?
buffered
cli-command
console
host
syslog
(Netgear Switch Routing) (Config)#logging host ?
<hostaddress>
reconfigure
remove
(Netgear Switch Routing) (Config)#logging host 192.168.21.253 ?
<cr>
Press Enter to execute the command.
<port>
Enter Port Id
300 |
Chapter 17. Syslog
#config
Buffered (In-Memory) Logging Configuration.
CLI Command Logging Configuration.
Console Logging Configuration.
Enter IP Address for Logging Host
Syslog Configuration.
Enter Logging Host IP Address
Logging Host Reconfiguration
Logging Host Removal
ProSafe 7000 Managed Switch Release 8.0.3