NETGEAR GSM7228PS Software Administration Manual page 77

ProSafe 7000 Managed Switch Release 8.0.3
(Netgear Switch) (Config)#ex
(Netgear Switch) #show ip ospf neighbor interface all
Router ID
----------------
4.4.4.4
2.2.2.2
(Netgear Switch) #show ip route
Total Number of Routes......................... 4
Network
Address
--------------- --------------- ------------
14.1.1.0 255.255.255.0
14.1.2.0 255.255.255.0
255.255.255.0
192.168.20.0 255.255.255.0
Web Interface: Configure Area 1 as a Stub Area on A1
1. Enable IP routing on the switch.
a. Select Routing > IP > Basic > IP Configuration. A screen similar to the following
displays.
b. For Routing Mode, select the Enable radio button.
c. Click Apply to save the settings.
2. Assign IP address 192.168.10.1 to port 2/0/11.
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
IP Address Neighbor Interface
----------- -------------------
192.168.10.2 2/0/11
192.168.20.2 2/0/19
Subnet
Mask Protocol
OSPF Inter
OSPF Inter
Local 2/0/11
Local
State
---------
Full
Full
Next Hop Next Hop
Intf IP Address
--------- ---------------
2/0/11 192.168.10.2
2/0/11 192.168.10.2
192.168.10.1
2/0/19 192.168.20.1
192.168.10.0
Chapter 7. OSPF | 77