NETGEAR GSM7228PS Software Administration Manual page 435

ProSafe 7000 Managed Switch Release 8.0.3
5. Redistribute 10.200.1.0/24 to the RIP such that RIP adviertises this route to the DHCP
server.
(Netgear Switch) (Config)#
(Netgear Switch) (Config)#router rip
(Netgear Switch) (Config-router)#redistribute connected
(Netgear Switch) (Config-router)#exit
Web Interface: Configure a DHCP L3 Relay
1. Enable routing mode on the switch.
a. Select Routing > IP > Basic > IP Configuration. A screen similar to the following
displays.
b. For Routing Mode, select the Enable radio button.
c. Click Apply.
2. Create a routing interface and assign 10.100.1.2/24 to it.
a. Select Routing > IP > Advanced > IP Interface Configuration. A screen similar to
the following displays.
b. Scroll down and select the Port 1/0/4 check box.
c. In the IP Address field, enter 10.100.1.2.
d. In the Subnet Mask field, enter 255.255.255.0.
e. In the Routing Mode field, select Enable.
Chapter 27. DHCP L2 Relay and L3 Relay | 435