NETGEAR GSM7228PS Software Administration Manual page 347

ProSafe 7000 Managed Switch Release 8.0.3
b. Under VLAN Membership, in the VLAN ID list, select 200.
c. Click Unit 1. The ports display.
d. Click the gray boxes under ports 6, 7, 16 and 17 until U displays. The U specifies
that the egress packet is untagged for the port.
e. Click Apply.
3. Specify the PVID on ports 1/0/6, 1/0/7, 1/0/16, and 1/0/17.
a. Select Switching > VLAN > Advanced > Port PVID Configuration. A screen similar
to the following displays.
b. Under PVID Configuration, scroll down and select the Interface 1/0/6,1/0/7,1/0/16,
and 1/0/17 check boxes.
c. In the PVID (1 to 4093) field, enter 200.
d. In the Acceptable Frame Type list, select Admit All.
e. Click Apply to save the settings.
4. Create a private group, group1.
a. Select Security > Traffic Control > Private Group VLAN > Private Group VLAN >
Private Group Configuration. A screen similar to the following displays.
b. In the Group Name field, enter group1.
c. In the Group ID field, enter 1.
d. In the Group Mode list, select community.
Chapter 22. Double VLANs and Private VLAN Groups | 347