NETGEAR GSM7228PS Software Administration Manual page 365

ProSafe 7000 Managed Switch Release 8.0.3
(Netgear Switch) #show ipv6 interface 1/0/1
IPv6 is enabled
IPv6 Prefix is ................................ FE80::21E:2AFF:FED9:249B/128
Routing Mode................................... Enabled
Administrative Mode............................ Enabled
IPv6 Routing Operational Mode.................. Enabled
Bandwidth...................................... 1000000
Interface Maximum Transmit Unit................ 1500
Router Duplicate Address Detection Transmits... 1
Router Advertisement NS Interval............... 0
Router Advertisement Lifetime.................. 1800
Router Advertisement Reachable Time............ 0
Router Advertisement Interval.................. 600
Router Advertisement Managed Config Flag....... Disabled
Router Advertisement Other Config Flag......... Disabled
Router Advertisement Suppress Flag............. Disabled
IPv6 Destination Unreachables.................. Enabled
Prefix 2000::2/64
Preferred Lifetime............................. 604800
Valid Lifetime................................. 2592000
Onlink Flag.................................... Enabled
Autonomous Flag................................ Enabled
Web Interface: Create an IPv6 Routing Interface
1. Enable IPv6 forwarding and unicast routing on the switch.
a. Select Routing > IPv6 > Basic > Global Configuration. A screen similar to the
following displays.
b. For IPv6 Unicast Routing, select the Enable radio button.
c. For IPv6 Forwarding, select the Enable radio button.
d. Click Apply.
2. Enable IPv6 routing on interface 1/0/1.
2000::2/64 [TENT]
kbps
Chapter 25. IPv6 Interface Configuration | 365