IPv6 Interface Configuration
25.
This chapter provides the following examples:
•
Create an IPv6 Routing Interface
•
Create an IPv6 Routing VLAN
Create an IPv6 Routing Interface
The example is shown as CLI commands and as a Web interface procedure.
CLI: Create an IPv6 Routing Interface
1.
Enable IPV6 forwarding and unicast routing on the switch.
(Netgear Switch) (Config)#ipv6 forwarding
(Netgear Switch) (Config)#ipv6 unicast-routing
2.
Assign an IPv6 address to interface 1/0/1.
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#ipv6 enable
(Netgear Switch) (Interface 1/0/1)#ipv6 address 2000::2/64
(Netgear Switch) (Interface 1/0/1)#routing
(Netgear Switch) (Interface 1/0/1)#exit
(Netgear Switch) #ping ipv6 2000::2
Send count=3, Receive count=3 from 2000::2
Average round trip time = 1.00 ms
(Netgear Switch) #show ipv6 brief
IPv6 Forwarding Mode........................... Enable
IPv6 Unicast Routing Mode...................... Enable
IPv6 Hop Limit................................. 0
ICMPv6 Rate Limit Error Interval............... 1000 msec
ICMPv6 Rate Limit Burst Size................... 100 messages
Maximum Routes................................. 12
on page 368
Chapter 25. IPv6 Interface Configuration
25
| 364