Configure A Stacking Port As An Ethernet Port - NETGEAR GSM7228PS Software Administration Manual

4. Continue with the boot of operational code.
5. Once the stack is up, download the saved configuration back to the master. This
configuration should then be automatically propagated to all members of the stack.
Copy Master Firmware to a Stack Member (Web Interface)
1. Select System > Management > Basic > Stack Configuration. A screen similar to the
following displays.
2. In the Copy Master Firmware to Unit list, select 2.
3. Click Apply.

Configure a Stacking Port as an Ethernet Port

Figure 34. Configuring a stacking port as an Ethernet port
Follow these steps to set up the topology:
1. Insert the AX742 into the I/O module on the switch.
2. Configure the switch A and B as described in the following instructions.
3. Connect the AX 742 with stack cable.
4. Reboot Switch A and Switch B.
308 | Chapter 18. Switch Stacks
AX742 AX742
2/0/28 1/0/28
ProSafe 7000 Managed Switch Release 8.0.3