Unpacking The Router - Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual

Unpacking the Router

•
Before starting the installation procedures in this chapter, see the
page 2-34
For information on installing modules, refer to the Cisco 7600 Series Router Module Installation Guide.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Before working on a chassis or working near power supplies, unplug the power cord on AC units;
Warning
disconnect the power at the circuit breaker on DC units.
Warning The plug-socket combination must be accessible at all times because it serves as the main
disconnecting device.
Warning TThis unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Warning There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with
the same or equivalent type recommended by the manufacturer. Dispose of used batteries according
to the manufacturer's instructions.
Class 1 laser product.
Warning
Because invisible laser radiation may be emitted from the aperture of the port when no cable is
Warning
connected, avoid exposure to laser radiation and do not stare into open apertures.

Unpacking the Router

Do not discard the shipping container when you unpack the router. Flatten the shipping cartons and store
Tip
them with the pallet. You will need these containers if you need to move or ship the router in the future.
Repacking instructions are provided in
Perform the following to check the contents of the shipping container:
•
Cisco 7600 Series Router Installation Guide
3-2
Verifying Router Chassis Installation, page 3-30
to verify that all site planning activities were completed.
Check the contents of the accessories kit against the Accessories Kit Components Checklist and the
packing slip. Verify that you received all listed equipment, which should include the following:
Hardware and software documentation, if ordered
–
Optional equipment that you ordered, such as network interface cables, transceivers, or special
–
connectors
Chapter 3
Appendix D, "Repacking the Cisco 7600 Series Router."
Installing the Cisco 7600 Series Router
"Site Planning Checklist" section on
OL-4503-26