Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual page 106

Installing the Cable Management System (Cisco 7609 Router and Cisco 7609-S Router Only)
The cable management system is included only in the accessory kit for the Cisco 7609
Note
router(CABLETRAY-09=) and Cisco 7609-S router(CABLETRAY-09S=). Do note that the extended
and the standard cable guides are included in the CABLETRAY-09= that is shipped with Cisco 7609
routers, and only the extended cable guide is included in the CABLETRAY-09S= shipped with Cisco
7609-S routers.
The cable management system is shipped with the extended cable guide installed, but can be used with
Note
the supplied standard cable guide. Use the extended cable guide with Ethernet and Fast Ethernet modules
(24 to 48 ports) using 10/100 cable. Use the standard cable guide with OSMs or other low port-density
modules (up to 16 ports) using fiber and coax cable. We recommend that you install the cable
management system before replacing the cable guide. See the
page 3-17
To install the cable management system, perform these steps:
Place the cable management system against the chassis, as shown in
Step 1
installation screws.
Step 2 Assure that the hinge is flat against the chassis, and install four 6x32 screws to secure the back plate to
the chassis.
Figure 3-16
Note
Cisco 7600 Series Router Installation Guide
3-16
for replacement procedures.
Installing the Cable Management System
Captive installation screws
FAN
STATU S
FAN
1
FAN
2
Hinge screws
To route the cables through the cable guide, remove the front panel and attach the interface
cables to the modules. See the
information on attaching the interface cables.
Chapter 3
"Replacing the Cable Guide" section on
"Attaching the Interface Cables" section on page 3-25
Installing the Cisco 7600 Series Router
Figure 3-16, and tighten the captive
OL-4503-26
for