Connecting To The Interface Ports - Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual

Attaching the Interface Cables
Remove the plugs from the Gigabit Interface Converter (GBIC) optical bores; store them for future use.
Step 1
Remove the plugs from the SC-type connector on the fiber-optic cable. Insert the connector into the
Step 2
GBIC. (See
Figure 3-27
Note When you plug the SC-type connector into the GBIC, make sure that both the transmit (Tx) and receive
(Rx) fiber-optic cables are fully inserted into the SC-type connector.
Note If you are using the LX/LH GBIC with MMF, you need to install a patch cord between the GBIC and the
MMF cable.

Connecting to the Interface Ports

For connector specifications, see
Note
For information on cleaning optical interfaces, see
Note
http://www.cisco.com/warp/public/127/cleanfiber2.html.
The Optical Services Modules (OSMs) and supported Catalyst 6500 series modules have the following
interface ports:
•
•
•
•
•
Cisco 7600 Series Router Installation Guide
3-28
Figure 3-27.)
Connecting the Supervisor Engine Uplink Ports
SC-Type fiber-optic connectors. (See
LC fiber-optic connectors. (See
MT-RJ fiber-optic connector. (See
Mini-SMB cable connector. (See
RJ-45—Catalyst 6500 series 48-port 10/100TX switching modules. (See
Appendix B, "Connector and Cable Specifications."
Figure 3-28.)
Figure 3-29.)
Figure 3-30.)
Figure 3-31.)
Chapter 3 Installing the Cisco 7600 Series Router
Figure 3-32.)
OL-4503-26