Cisco 7604 Router - Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual

Cisco 7604 Router

The GBIC uplink ports are fully functional on the redundant supervisor engine in standby mode.
Note
Slots 3 and 4 are available for OSMs or other supported Catalyst 6500 series modules.
The Cisco 7604 router supports the following supervisor engines:
Supervisor Engine 720 (with PFC3B or PFC3BXL)
•
Supervisor Engine 32
•
Route Switch Processor 720
•
The Cisco 7604 router does not support Supervisor Engine 2.
Note
The Switch Fabric Module is not supported on the Cisco 7604 router.
Note
The Cisco 7604 router also supports:
Up to three of the following hot-swappable line cards:
•
–
–
–
–
Hot-swappable fan assembly
•
Redundant AC-input or DC-input power supplies (2700 W)
•
Redundant DC-input or DC-input power supplies (2700 W)
•
The power supplies are installed from the rear of the chassis. (See
For a detailed description of supervisor engine operation in a redundant configuration, refer to the
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide.
Cisco 7600 Series Router Installation Guide
1-6
OSMs
Catalyst 6500 series modules
Carrier cards (SIP-200, SIP-400, SIP-600)
FlexWAN or Enhanced FlexWAN modules
Chapter 1 Product Overview
Figure 1-6.)
OL-4503-26