Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual page 242

Removing and Replacing the PEM
Remove the power cord from the power connection on the PEM. Do not touch the metal prongs
Step 3
embedded in the PEM.
Step 4 Loosen the captive installation screws
Figure 5-109
Captive installation screws
Grasp the PEM with one hand, and slide it part of the way out of the chassis. Place your other hand
Step 5
underneath the PEM, as shown in
Figure 5-110
If the PEM bay is to remain empty, install a blank PEM filler plate (Cisco part number 800-16719-01)
Step 6
over the opening, and secure it with the captive installation screws. See
Cisco 7600 Series Router Installation Guide
5-114
AC-Input PEM
IEC 60320 C15 connector
AC power switch
Handling a PEM
WS-X6K -SUP2-2 GE
CONSOLE
SUPERV ISOR2
OSM-4OC1 2 POS-SI
4 PORT OC-12 POS SM
IR
OSM-4OC1 2 POS-SI
4 PORT OC-12 POS SM
IR
(Figure 5-109).
Figure 5-110, and slide it completely out of the chassis.
Switch
Load
CONSOLE 100%
PORT
PORT 1
MODE
PCMCIA
EJECT
1%
Chapter 5 Removal and Replacement Procedures
PORT 2
Figure 5-111.
OL-4503-26