Cisco 7600-SIP-400 - SPA Interface Processor 400 Installation Manual page 30

Cisco 7606-S Router
Cisco 7606-S Router
The Cisco 7606-S router chassis has six horizontal slots that are numbered from top to bottom. (See
Figure
The Cisco 7606-S router supports the following:
•
•
•
•
•
•
For a detailed description of supervisor engine operation in a redundant configuration, refer to the
Cisco 7600 Series Router Supervisor Engine and Route Switch Processor Guide.
The power supplies are installed from the rear of the chassis. (See
Cisco 7600 Series Router Installation Guide
1-10
1-9.)
Both supervisor engines in a single chassis must be completely identical.
Note
A Supervisor Engine 720 in slot 5 and an optional redundant Supervisor Engine 720 in slot 6. Each
supervisor engine provides switching, local and remote management. The Supervisor Enigne 720
has two GBIC uplink ports and one 10/100/1000 Tx port. Only two of the three ports can be active
at any one time.
Note The GBIC uplink ports are fully functional on the redundant supervisor engine in standby
mode.
A Supervisor Engine 32 in slot 5 and an optional redundant Supervisor Engine 32 in slot 6. Each
supervisor engine provides switching, local and remote management.
A Route Switch Processor 720 in slot 5 and an optional redundant Route Switch Processor 720 in
slot 6. Each supervisor engine provides switching, local and remote management.
Both supervisor engines in a single chassis must be completely identical.
Note
Up to five additional hot-swappable line cards or Catalyst 6500 series modules
Hot-swappable fan assembly
Redundant AC-input and DC-input or DC-input power supplies
Chapter 1 Product Overview
Figure 1-10.)
OL-4503-26